![]() Please wait a few minutes and refresh this page. AutoLISP: Replace Selected Points with BlockĮrror: Twitter did not respond.Change the "Standard" Font in AutoCAD Template.This creates the new text line below the Dim value and the Dimension line.Ībove: Properties palette where \X is enteredĪbove: Text below Dimension Value and Dimension Line The Important thing is the \X portion.I used the following to achieve the below text: \XNotes below dimline.Scroll down in the Properties Palette to the Text section of the Palette and then activate the “Text override” text box.Right click and open the Properties palette.To add text that is below the dimension value and the dimension line: move the text cursor to the right of the dimension value and hit This will create the new line below the dim value.Type ED in at the command line and hit.To add text so that is underneath the dimension but also above the dimension line: The first 2 points need to be aligned and on the same axis. Turn on Center and Node snaps, also turn on Polar Tracking as shown in video above. I thought that it would be helpful to show that you don’t need a lisp routine to do this. Now Piping Spools or any 3D object can be dimensioned at any angle using just a few basic steps. I have seen a few Lisp routines that allow you to add a line of text under your dimension.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |